Beginning of this page
Jump to main content

Please note that JavaScript and style sheet are used in this website,
Due to unadaptability of the style sheet with the browser used in your computer, pages may not look as original.
Even in such a case, however, the contents can be used safely.

Products > Packages > Semiconductor Device Mount Manual > PRINTED WIRING BOARD DESIGN >

CHAPTER 2 PRINTED WIRING BOARD DESIGN


2.3 THDs
2.3.1 Tolerance of package dimensions

The tolerance described in the package drawing of an 8 pin plastic DIP (7.62 mm (300)) is explained below.




 

Figure 2-15. Package Drawing of 8-Pin Plastic DIP (7.62mm(300))


The precision of the package pins in this diagram is guaranteed from the positional tolerance indicated by the logically accurate dimensions (dimension of square circumference: pin row interval/pitch), pin width/thickness tolerance, and pin position variation range.

[ Logically accurate dimensions ]


[ Pin width/thickness tolerance ]


[ positional tolerance: indicating the range of shift of the pin center position ]

Table 2-15. Description of Geometrical Tolerance
Symbol(211B) Symbol indicating the positional tolerance.
0.25 symbol(425B) Numerical value indicating that the positional tolerance of the pin center is in the range of x = 0.25 mm.
Allowable range that each pin center can deviate from the logically accurate dimensions when parallel chucking is performed at a pin row interval of e1 symbol(360B) = 7.62 mm for both pin rows of the DIP package.
Symbol indicating that the positional tolerance can be up to x = 25 mm, based on a pin width of b MAX = 0.60 mm.(i.e. If the pin width b is less than the maximum value, the tolerance will be greater than x = 0.25 mm)

To 2.2.2 Exrmple of mount pad dimensionTo 2.3.2 Pin existence range calculation