Please note that JavaScript and style sheet are used in this website,
Due to unadaptability of the style sheet with the browser used in your computer, pages may not look as original.
Even in such a case, however, the contents can be used safely.
µPD16835
Stepping Motor Driver
Monolithic Quad H Bridge Driver Circuit
Overview
The µPD16835 is a monolithic quad H bridge driver IC that employs a CMOS control circuit and a MOS FET output circuit. Because it uses MOS FETs in its output stage, this driver IC consumes less power than conventional driver ICs that use bipolar transistors.
Because the µPD16835 controls a motor by inputting serial data, its package has been shrunk and the number of pins reduced. As a result, the performance of the application set can be improved and the size of the set has been reduced.
The µPD16835 employs a current-controlled 64-step micro step driving method that drives stepper motor with low vibration.
The µPD16835 is housed in a 38-pin plastic shrink SOP to contribute to the miniaturization of the application set.
The µPD16835 can simultaneously drive two stepper motors and is ideal for the mechanisms of camcorders.
Features
- Four H bridge circuits employing power MOS FETs
- Current-controlled 64-step micro step driving
- Motor control by serial data
(8 bytes x 8 bits)(original oscillation: 4-MHz input)
Data is input with the LSB first.
EVR reference setting voltage:
100 to 250 mV (@VREF = 250 mV) ... 4-bit data input (10-mV step)
Chopping frequency: 32 to 124 kHz ... 5-bit data input (4-kHz step)
Original oscillation division or internal oscillation selectable
Number of pulses in 1 VD:
0 to 252 pulses ... 6 bits + 2-bit data input (4 pulses/step)
Step cycle: 0.25 to 8191.75 ms ... 15-bit data input (0.25-µs step) - Low current consumption
IDD: 3.0 mA (MAX.)
IDD (RESET): 100 µA (MAX.)
IMO(RESET): 1.0 µA (MAX.) - 38-pin plastic SSOP (7.62 mm (300))
Ordering Information
|
Document
Block Diagram
