Please note that JavaScript and style sheet are used in this website,
Due to unadaptability of the style sheet with the browser used in your computer, pages may not look as original.
Even in such a case, however, the contents can be used safely.
On-board Programming
This programming method consists in programming the flash microcontroller after it has been mounted on the target system.
- Programming interface pins are to be provided on the target system.
- The programming interface differs depending on the product.
Select the right product by checking the user's manual of each product. - If 3-wire serial H/S is supported, the use of the serial H/S enables faster writing.
- The flash microcontroller on the board can be programmed regardless of whether if it has already been programmed or is blank.
- Flash microcontrollers can be programmed even inline (on production lines).
Below is an example of the on-board programming setup in which the PG-FP5 flash programmer of NEC Electronics is used.
Using programming GUI
In stand alone mode
© 1995-2008 NEC Electronics Corporation
