Please note that JavaScript and style sheet are used in this website,
Due to unadaptability of the style sheet with the browser used in your computer, pages may not look as original.
Even in such a case, however, the contents can be used safely.
Off-board Programming
This programming method consists in programming the flash microcontroller before it has been mounted on the target system.
- A programadapter board that supports the package to be used is to be prepared.
- The programming interface differs depending on the product.
Select the right product by checking the user's manual of each product. - If 3-wire serial H/S(Hand Shake) is supported, the use of the serial H/S(Hand Shake) enables faster writing.
- Flash microcontrollers can be programmed regardless of whether they have already been programmed or are blank.
Below is an example of the off-board programming setup in which the PG-FP5 flash memory programmer of NEC Electronics is used.
Using programming GUI
In stand alone mode
© 1995-2008 NEC Electronics Corporation
