Please note that JavaScript and style sheet are used in this website,
Due to unadaptability of the style sheet with the browser used in your computer, pages may not look as original.
Even in such a case, however, the contents can be used safely.
Japan
Development Tool Parts
Contents
FAQ-ID : com_part-nnnn
| 0001 | Weight and size of EV-9200G-80 conversion socket |
|---|---|
| 0002 | Projections of EV-9200G-80 conversion socket |
| 0003 | Can reflow soldering be used for the EV-9200G-80 ? |
Weight and size of EV-9200G-80 conversion socket
FAQ-ID : com_part-0001
- Q-1
-
What is the conversion socket EV-9200G-80's weight and size?
- A-1
-
The actually measured values are as follows.
Weight: 80g
Dimensions: 132 x 95 x 27 (mm)
These measured values are not overly strict measurements.
Please use them for reference purposes only.
Projections of EV-9200G-80 conversion socket
FAQ-ID : com_part-0002
- Q-1
-
There are two projections on the socket, but since I do not want to make new holes in the PCB, can I cut off these projections?
- A-1
-
These projections are for positioning on the PCB.
If you remove these projections, be very careful about correct positioning and position fixing, because of the risk of slippage during soldering and also the risk of short circuits between neighboring pins.
Can reflow soldering be used for the EV-9200G-80 ?
FAQ-ID : com_part-0003
- Q-1
-
Can reflow soldering be used for board mounting of the EV-9200GC-80 conversion socket?
- A-1
-
The EV-9200GC-80 does not support reflow soldering.(Reflow soldering is not possible.)
Therefore solder this part by hand.
© 1995-2010 NEC Electronics Corporation